Repair Rake Edge On Craftsman?

Roof repairs typically involve replacing damaged shingles and rusted flashing, but the overhang of a roof is often the first surface area to succumb to rot, peeling paint and other weather-related bug. The good news is, unlike most roof repairs, y'all can fix an eave or gable overhang (rake) without climbing onto the roof.

Soffited eaves and gable overhangs are susceptible to h2o harm caused past water ice dams, improper flashing, torn shingles, and faulty gutters. And once h2o has seeped in, the rot spreads quickly because the wood stays soggy inside the dark, dank infinite.

Impairment is likewise caused by birds and squirrels nesting inside eaves. These animals accept been known to chew or peck through a perfectly sound eave, just they're peculiarly attracted to a h2o-damaged fascia or soffit, which offers less resistance. Bees and hornets also build nests in and under eaves. Phone call an exterminator if you notice bees or hornets congregating around an eave — fifty-fifty if you don't run across the nest.

Soffit and Fascia Repair

1. Remove Shingle Mold

Pry the narrow shingle mold from the fascia using a flat bar. If information technology comes off without splitting, reuse it afterwards.

two. Remove Rotted Fascia

Remove the rotted section of fascia. Be conscientious not to damage whatever nearby roof shingles or flashing.

3. Remove Sometime Soffit

Pull downward to remove the old soffit. Notation that a squirrel had built a large nest above the soffit shown here.

4. Remove Rotted Rafter

Use a reciprocating saw to chop out the rotted rafter. Cut a replacement piece from pressure-treated lumber.

5. Adhere Cleat

Utilize a powder-actuated nailer to attach a 2x4 cleat to a brick chimney. The cleat helps support the new overhang.

half-dozen. Attach New Rafter

Clamp a ane-by backing board in identify and screw the new rafter to information technology. Spiral the rafter to the chimney cleat as well.

vii. Seal Replacement Soffit

Protect the edges of the plywood soffit from water penetration with a waxy sealer, such as AnchorSeal.

viii. Attach Replacement Soffit

Fasten the plywood soffit to the underside of the eave or rake subsequently priming both the height and bottom surfaces.

nine. Replace Crown Molding

Replace the section of crown molding forth the wall of the house direct beneath the rear border of the new soffit.

ten. Attach Replacement Fascia

Slide the new fascia into place, then attach information technology with galvanized nails. Set the nails and putty the holes.

eleven. Attach Shingle Mold

Attach the shingle mold along the pinnacle of the fascia. Employ a tape measure to maintain a consistent reveal.

---

Tools

Source: https://www.thisoldhouse.com/roofing/21016606/how-to-repair-a-rotted-soffit

Posted by: hardenbace1941.blogspot.com

Share this post